Services and pricing

For homeowners and small offices adding cooling to one room. We size the unit to the space, run the pipework through the wall, and commission the system before leaving. The result is a working unit with a documented commissioning record.

• ✓Room load calculation before quoting
• ✓Indoor and outdoor unit fitted and levelled
• ✓Pipework routed, insulated and sealed
• ✓Electrical connection to a dedicated isolator

For units that have gone musty or are blowing weaker than they used to. We strip the casing, steam-clean the coil and filters, and flush the drain line. Airflow and smell are usually noticeably improved by the time we leave.

• ✓Casing opened and wiped down inside and out
• ✓Evaporator coil steam-cleaned
• ✓Filters washed or replaced
• ✓Condensate drain line flushed

For owners who want to avoid mid-summer failures. We check refrigerant pressure, electrical connections, drainage and controls against the manufacturer's checklist. Any wear is flagged with a written note rather than fixed on the spot without agreement.

• ✓Refrigerant pressure check
• ✓Electrical connections tightened and tested
• ✓Drain line and tray checked for blockage
• ✓Filters cleaned or replaced

For units that cool less effectively than they used to, which is often a sign of a slow leak. We pressure test the system, locate obvious leak points where possible, and recharge to the correct weight for the unit. The job includes a note on what was found.

• ✓Pressure test before recharging
• ✓Leak check at accessible joints
• ✓Recharge to manufacturer specification
• ✓Weighed-in refrigerant, not a guess

For units that have stopped working, are tripping the electrics, or are making noise they shouldn't. We diagnose first, quote for any parts needed, and only proceed with repair once you have agreed the cost. Call-outs in the Birmingham area are usually arranged for the same or next working day.

• ✓Electrical and mechanical fault check
• ✓Error code reading on digital controls
• ✓Capacitor, fan motor and board checks
• ✓Written quote before any repair work

For properties where the original condenser position is noisy, visible from the street, or blocking building work. We extend or reroute the refrigerant line, re-insulate it, and re-test the system so performance is not affected by the extra run.

• ✓Assessment of maximum allowable pipe run
• ✓New pipework run and insulated
• ✓Condenser relocated and re-mounted
• ✓Vacuum and pressure test on the new run

For offices, shops and larger homes needing more than one room cooled from a single outdoor unit. We design the layout, size the condenser to the combined load, and schedule installation around working hours where needed. Suits landlords and businesses as much as larger households.

• ✓Building survey and load calculation
• ✓System design for multiple indoor units
• ✓Condenser sized to combined capacity
• ✓Pipework and cabling routed discreetly

A short, focused visit for anyone noticing a stuffy room or wanting a quick check between full services. We replace or wash filters and check for visible dust or mould buildup inside the casing, flagging anything that needs a fuller clean.

• ✓Filter condition check
• ✓Wash or replacement as needed
• ✓Internal casing inspection
• ✓Dust and mould check on visible surfaces